<aside> 💡 Preheating water will make the steaming process faster. This will make sure the coffee grounds are not spending too much time on the stove and reduces the probability of them getting burnt. The aluminum pot can get quite hot.
</aside>
<aside> 💡 Tamping will make it difficult for water to push through the grounds. As there is no machine pressure in Moka pot, the pressure comes from water getting to too high of a temperature which may burn the coffee grounds. Also, make sure the coffee grounds are consistent (no big blobs) so that water flows uniformly throughout.
</aside>
<aside> 💡 Medium heat will make the process slow enough for coffee grounds and water to spend some good time together extracting all the goodness until the steam below will eventually push it up. High heat will hasten this process and the extraction will be bad. Also, if the seal is not tight, the pressure inside is not maintained, and some water will spurt through. This is bad for extraction.
</aside>
<aside> 💡 Think about that start up idea that you always wanted to pursue!
</aside>
<aside> 💡 Water that spurts out is the final steam that came out of the chamber and did not spend enough time with coffee grounds. Its not worth mixing with the rest of the goodness. Alternately, you can turnoff the heat when three-fourths of the coffee is out and let the rest slowly drip out.
</aside>
<aside> 💡 Enjoy your craziness that is coffee.
</aside>
Moka pot:
Costly one:
Cheaper one (still gets the job done):